MDF Waste Board / Plate

1. Mount the plate, there should be 5 screws, 1 in each corner and 1 in the center.
2. Use double-sided tape to secure your material to the MDF plate
3. Burnish down the tape
4. Push down FIRMLY

Possible File Sources

• thingiverse
• Carbide Community forum post
  • Carbide community forum random SVG

Low-Profile Vice

• 2″ x 8″
• 6.5″ Maximum clamping width
• Attach sideways to the Nomad using the button head screws

Usage

• Move inner moving jaw against the material, THEN lock in the outer moving jaw
• Tighten the 2 vertical screws in the outer jaws, then lock piece in w/ the horizontal/angled screws

Corner Jig

• Has consistent right-angle reference at one corner

Threaded Table

• ~0.5″ thick
• ~50 M6x1 threaded holes
• Attach to the Nomad w/ 5 M6 screws
• Intended for greater flexibility in work-holding options
  • Ex/ The Tiger-Claw clamps can be mounted into this plate

Flip Jig

• “allows you to cut both sides of a part while maintaining perfect alignment”
• can hold material < 3″ x 5″ x 1.2″
• Useful for two-sided machining
• Mounts to the corners on the MDF plate